Dell Dimension L c Series, Reference And Troubleshooting Manual

Page: 145 / 174

Diagnostic Codes, Beep Codes, and System Messages C-3
Recovery mode from
BIOS failure.
Set the configuration jumper to
Maintenance mode (see
Table 2-2) and restart the sys-
tem. Exit and save changes in
the system setup program. Turn
off the computer and reset the
configuration jumper to Normal
mode, and then restart the
system.
Remove all expansion cards and
restart the system to determine
if a resource conflict exists. If a
conflict exists, resolve the con-
flict as described in "Resolving
Software and Hardware Incom-
patibilities" in Chapter 5. If the
problem persists, refer to
Chapter 7, "Getting Help," for
instructions on obtaining techni-
cal assistance.
Microprocessor has
failed a BIOS test.
Refer to Chapter 7, "Getting
Help," for instructions on obtain-
ing technical assistance.
Memory failed to be
sized or enabled.
Reseat the DIMMs as described
in “Reseating DIMMs” in
Chapter 6. If the problem per-
sists, refer to Chapter 7, “Getting
Help,” for instructions on
obtaining technical assistance.
7DEOH&'LDJQRVWLF&RGHV FRQWLQXHG
'LDJQRVWLF&RGH 'HILQLWLRQ &RUUHFWLYH$FWLRQ
NOTE: The Glossary in the system Help defines abbreviations and acronyms.
A B C D
A B C D
A B C D