Dell Dimension L c Series, Reference And Troubleshooting Manual

Page: 129 / 174

System Setup Program B-7
3HULSKHUDO&RQILJXUDWLRQ6XEPHQX
)LJXUH%3HULSKHUDO&RQILJXUDWLRQ6XEPHQX
7DEOH%3HULSKHUDO&RQILJXUDWLRQ6XEPHQX2SWLRQV
2SWLRQ )XQFWLRQ
Serial port A Configures the serial port. Set this option to Auto (default),
Enabled , or Disabled . If set to Enabled , you can set the fol-
lowing additional options:
Base I/O
Address
Available I/O addresses are 3F8 , 3E8 , 2F8 , and 2E8 .
Interrupt Available interrupts are IRQ3 and IRQ4 .
Parallel port Configures the parallel port. Set this option to Auto (default),
Enabled , or Disabled . Depending on the port setting, you
can set the following additional options:
Mode If port is set to Auto or Enabled , available modes are
Output Only , Bi-Directional , ECP (default), and EPP .
NOTE: Refer to the device manufacturer's documentation
for information on which mode to use before changing this
setting.
Base I/O
Address
If port is set to Enabled , available I/O addresses are 378
(default), 278 , and 228 .
Interrupt If port is set to Enabled , available interrupts are 7 and 5 .
NOTE: The Glossary in the system Help defines abbreviations and acronyms.