Dell Dimension 2010, Service Manual

Page: 43 / 78

Power Switch Module
43
8
Power Switch Module
WARNING:
Before working inside your computer, read the safety information
that shipped with your computer. For additional safety best practices information,
see the Regulatory Compliance Homepage at
www.dell.com/regulatory_compliance.
WARNING:
To guard against electrical shock, always unplug your computer from
the electrical outlet before removing the cover.
WARNING:
Do not operate your equipment with any cover(s) (including computer
covers, bezels, filler brackets, front-panel inserts, etc.) removed.
CAUTION:
Ensure that sufficient space exists to support the system with the
cover removed—at least 30 cm (1 ft.) of desk top space.
Removing the Power Switch Module
1 Follow the procedures in "Before You Begin" on page 11.
2 Remove the computer cover from both the sides (see "Removing the
Computer Cover" on page 15).
3 Remove the front bezel (see "Removing the Front Bezel" on page 19).
4
Remove the hard drive (see "Removing a Hard Drive" on page 31).
5
Disconnect the power switch module cable from power switch module
connector (FP1) on the system board. For the location of the connector,
see "System Board Components" on page 8.
6
Gently release the hard drive activity light from its holder.
7 Press the holder and rotate it outwards to remove it from the front panel.
book.book Page 43 Monday, November 19, 2012 11:42 AM