CLI equivalent
Steps
1. To set up the administrator email, enter:
# config set admin-email [email protected]
The Admin Email is: [email protected]
2. To register the system to the gateway (Secure Remote Support), enter:
# support connectemc device register ipaddr esrs-gateway [host-list] [ha-peer ipaddr]
CAUTION:
When configuring Secure Remove Services delivery on an HA pair:
●
The
ha-peer
parameter is required when configuring Secure Remote Services on HA pairs to register
both nodes.
●
The customer must provide Service Link credentials to run the
support connectemc device register
command on an HA pair, because attempting to register the HA pair as a user will fail and cause the RSA
key token to become out of synch.
3. To enable the sending of autosupports, enter:
# support notification enable all
Enabled sending autosupport and alerts to EMC.
4. To set the notification method to ConnectEMC, enter:
# support notification method set connectemc
Support notification method set to "connectemc".
5. To show the notification setup, enter:
# support notification show all
Notification Status Destination
------------ ------- -----------------------
alerts enabled ftp://111.111.11.111:11
autosupport enabled ftp://111.111.11.111:11
------------ ------- -----------------------
6. To show the notification setup, enter:
# support connectemc config show
ConnectEMC configuration:
ESRS gateway IP/hostname: esrs-gateway.datadomain.com
Registered device IP(s) 10.25.246.70
7. To test the configuration after enablement, enter:
# support connectemc test
Sending a test event...
Configure HA
Prerequisites
●
The HA interconnect between both nodes is connected.
NOTE:
Connecting the HA interconnect
on page 59 describes how to cable the HA interconnect.
●
The data connections on both nodes are connected.
About this task
Configure the two nodes as an HA pair.
NOTE:
Configuring an HA pair sets the system password on the standby node to match the system password on the active
node, however, that synchronization is not set until the HA configuration is complete. If the HA configuration fails, or if
82
Configure System for Use
Summary of Contents for PowerProtect DD9400
Page 1: ...Dell EMC PowerProtect DD9400 System Installation Guide September 2020 Rev 03...
Page 57: ...Figure 65 Single node DD9400 with DS60 shelves Connect Cables and Power On 57...
Page 58: ...Figure 66 HA DD9400 with DS60 shelves 58 Connect Cables and Power On...
Page 63: ...Figure 72 Routing cables through the CMA brackets Connect Cables and Power On 63...
