Figure 73. iDRAC Settings > Network
7. Press
Esc
to return to the previous menu.
8. Select
User Configuration
.
a. Enable the root user.
b. Change the root user password.
NOTE:
The default password is the system serial number. The system serial number is always on the service tag at
the front of the system, and on the PSNT tag attached to the rear handle of the chassis if the system has a rear-
mounted PSNT tag.
Figure 74. iDRAC Settings > User Configuration
Next steps
The
DD OS Administration Guide
describes how to power the system on and off with iDRAC.
The
DD OS, PowerProtect DD Virtual Edition, and PowerProtect DD Management Center Security Configuration Guide
provides
additional information about accessing security settings in iDRAC.
Configure System for Use
65
Summary of Contents for PowerProtect DD9400
Page 1: ...Dell EMC PowerProtect DD9400 System Installation Guide September 2020 Rev 03...
Page 57: ...Figure 65 Single node DD9400 with DS60 shelves Connect Cables and Power On 57...
Page 58: ...Figure 66 HA DD9400 with DS60 shelves 58 Connect Cables and Power On...
Page 63: ...Figure 72 Routing cables through the CMA brackets Connect Cables and Power On 63...
