5. Remove LED and cable. LED is removed by squeezing the
sides of the LED housing and pushing it forward.
Reassembly is the reverse of disassembly, with the following
exceptions:
1. Route and dress cables as in original unit. See section Speaker
Cable/LED Cable/Power Switch Cable Routing. Cable routes
behind 3.5˝ drive bay and through slot in Motherboard Tray.
Carefully install new cable ties at anchor points.
2. Adjust Motherboard Tray if needed - see section Adjusting the
Motherboard Tray.
Speaker and Cable Assembly
Removal and replacement of the Speaker and Cable assembly
requires removal of the Genesis MP front panel. Read and under-
stand that procedure before beginning.
Speaker in front panel.
The Speaker is located at the bottom center of the front panel and
connects to the motherboard at the connector on the top edge.
To remove and replace the Speaker:
1. Remove the Front Panel. See the section Genesis MP Front
Panel (metal).
2. Note the cable routing and existing anchor points. See section
Speaker Cable/LED Cable/Power Switch Cable Routing.
Carefully clip the cable ties attaching the Speaker Cable to
other cables and anchors. Cables are anchored on the inside of
the front panel and at the Genesis MP side wall (accessible
above the 3.5˝ drive bay).
3. Remove speaker and cable. Speaker is removed by unscrewing
the two nuts securing it to the front panel.
Genesis MP
Chapter 4 – Removal and Replacement
◆
57
