Genesis MP Motherboard
The Genesis MP motherboard is supported by an adjustable moth-
erboard tray, which permits adjustment of the fit between the moth-
erboard and the gasket at the rear of the machine. Normally, you
will only have to adjust the fit if the motherboard tray has been
removed or if a replacement motherboard is installed. Removal of
the motherboard is as follows:
1. Shut down the Genesis MP and remove power from the unit.
2. Open Genesis MP (loosen the side door panel) by following the
instructions in the Genesis MP User Guide.
3. Put on the anti-static wrist strap.
4. Remove any PCI Peripheral Expansion Cards. (refer to
Genesis MP Users Guide)
5. Remove the nPOWER daughter card. (refer to the section
nPOWER Processor Card)
6. Carefully remove the AV Module and cable (3-slot units only).
See section Audio/Video (AV) Module.
7. Remove the two nuts holding the PCI Bracket in place. Remove
the PCI Bracket.
PCI bracket
Chapter 4 – Removal and Replacement
Genesis MP
38
◆
