Genesis MP
Chapter 4 – Removal and Replacement
◆
55
3. Remove the Front Panel. See the section Genesis MP Front
Panel (metal).
4. Note the cable routing and existing anchor points. See section
Speaker Cable/LED Cable/Power Switch Cable Routing.
Carefully clip the cable ties attaching the Power Switch Cable to
other cables and anchors. Cables are anchored on the inside of
the front panel and at the Genesis MP side wall (accessible
through the 3.5˝ drive bay).
5. Remove switch and cable. Switch is removed squeezing the
sides of the switch housing and pushing it forward.
Replacement is the reverse of disassembly, with the following
exceptions:
1. Route and dress cables as in original unit. See section Speaker
Cable/LED Cable/Power Switch Cable Routing. Cable routes
behind 3.5˝ drive bay and through slot in Motherboard Tray.
Carefully install new cable ties at anchor points.
2. Adjust Motherboard Tray if needed - see section Adjusting the
Motherboard Tray.
Power Supply Power Switch units:
The Power Switch is located at the top of the front panel and con-
nects to a small pair of wires coming from the motherboard power
supply cable near the power supply.
Power supply
power switch connection
Removal and replacement of the Power Switch and Cable assem-
bly requires removal of the Genesis MP front panel. Read and
understand this procedure before beginning.
To remove and replace the Power Switch:
1. Remove any 3.5˝ drives installed in the 3.5˝ drive bay.
2. Remove the Front Panel. See the section Genesis MP Front
Panel (metal).
