DAVIS TECHNOLOGIES TC-3 Series, Instructions Manual

Page: 25 / 60

24
TC3 Series Traction Control
www.moretraction.com
Testing After Installation
After installation, it is recommended that you test all
inputs and outputs before headed to the track. This
can be achieved by a few different methods. The
easiest is with a Remote Display. Using the Utilities
Menu described later in this manual, you can test all
inputs and outputs.
If the Remote Display is not available, you can use
the Test button on the bottom of the unit to run
some simple test. This method will allow you to test
the output of the Timing Retard and SmartDrop®
outputs as well as RPM signal in. To activate the
test, follow these steps.
Press and Hold the Test Button
The Status LED will begin to rapidly flash
Green then turn to Orange.
Release the Test button to start the Timing
Retard Test
During the Timing test, the Launch LED will go
from dim to bright red over a few seconds.
SmartDrop® will then begin to output,
indicated by the ARM LED intensity increasing
in 4 steps
At the end of the test the Launch LED will be
off and will turn on if an RPM signal is
received from the sensor.