DAVIS TECHNOLOGIES TC-3 Series, Instructions Manual

Page: 41 / 60

40
TC3 Series Traction Control
www.moretraction.com
The TC3 can transmit selected data via CAN Bus.
When using multiple CAN Bus equipped products
from Davis Technologies in a vehicle, the CAN Bus
connections may simplify the installation.
The CAN Bus can also share information with other
systems in the vehicle, such as data or EFI systems.
Information on this can be found in the appendix C.
Davis Technologies does not provide extensive
support for CAN. An experienced CAN Bus
programmer should find the necessary information
in appendix C.
The CAN Base Address may be used to resolve
addressing conflicts should they arrive due to 2
systems using the same base address. Davis
Technologies’ devices are set by default to Base
Address 0004. All Davis devices must be set to the
same base address to communicate to each other.
CAN Base
Address
Save
+ +
- -
0 0
+ +
- -
0 4
CAN Base Address,
Adjust To Resolve
Conflict
The CAN Frequency determines the transmit rate at
which the network sends and receives data. Higher
speed requires proper wiring techniques, such as
twisted pair and shorter (<25ft) runs. Higher speeds
also require a termination resistor (120ohm)
installed at the end of the wiring run to prevent
signal bounce-back. We have found that in most