Datex-Ohmeda S/5 Compact Anesthesia Monitor, Technical Reference Manual

Page: 35 / 72

General Service Guide
Table 1 Transference of parameters, Datex-Ohmeda monitors
Device Waveforms (analog) Numerics Alarms
Cardiocap M-INT -> CO
2
Et&Fi Airway gases, Respiration
rate, SpO
2
, Pulse rate
None
Capnomac
Capnomac II M-INT -> CO
2
, Pleth Et&Fi Airway gases, Respiration
rate. None
Capnomac Ultima M-INT -> CO
2
Et&Fi Airway gases, Respiration
rate, Spirometry,SpO
2
, Pulse rate,
Pleth amplitude
CO
2
, O
2
, Anesthesia agent,
respiration rate, Apnea,
occlusion, SpO
2
, pulse rate.
Normocap 200
Normocap 200 OXY M-INT -> CO
2
Et&Fi Airway gases, Respiration
rate. None
Oscar
Oscar II
Oscar OXY M-INT -> CO
2
, Pleth Et&Fi Airway gases, Respiration
rate, SpO
2
, Pulse rate, Pleth
amplitude
None
Satlite
Satlite II
Satlite Plus M-INT -> CO
2
SpO
2
, Pulse rate, Pleth amplitude None
Satlite Trans None SpO
2
, Pulse rate, Pleth amplitude None
Table 2 Transference of parameters, external monitors
Device Waveforms Numerics Alarms
Critikon
Dinamap 1846SX None NIBP None
Abbott
Oximetrix 3 None SvO
2
/SaO
2
, CO None
Baxter
Explorer None C.O., SvO
2,
REF, Tblood None
Baxter
Vigilance None C.O., SvO
2,
C.C.O., Tblood None
Nellcor
N-100
N-200
N-1000 Pleth (analog) SpO
2
, Pulse rate None
4.1.1 Connection to external Datex-Ohmeda monitors
Use the INT-External Device Cable.
1.
Make sure that the power on both monitors is switched off.
2. Connect the 9 pin D-connector to one of the connectors on the Interface Module, M-INT.
Tighten the finger screws.
3. Connect the 25 pin D-connector to the corresponding connector on the interfaced monitor.
Tighten the finger screws.
4.1.2 Connection to Critikon Dinamap 1846SX, Abbott Oximetrix 3 and Baxter Explorer
Use the INT-External Device Cable.
1. Make sure that the power on both monitors is switched off.
2. Connect the 9 pin D-connector to one of the connectors on the Interface Module, M-INT.
Tighten the finger screws.
3. Connect the 25 pin D-connector to the corresponding connector on the interfaced monitor.
Tighten the finger screws.
Document No. M1031508
25