Datex-Ohmeda S/5 Compact Anesthesia and Critical Care Monitor
3.3.11 Performing Factory Reset
NOTE:
The factory reset is necessary after replacing monitor software.
NOTE:
The factory reset will restore all customized defaults, including language selection, to factory
defaults.
1. Press
the
Monitor Setup
key.
2. Select
Install/Service
and password (16-4-34).
3. Select
Service
and password (26-23-8).
4. Select
Set/ Test
and
Factory Reset
.
5.
The monitor will perform an automatic restart. After the restart is completed, restart the
monitor also manually.
3.4 S/5 Remote Controller, K-CREMCO
To connect S/5 Remote Controller, K-CREMCO to a S/5 Compact Monitor:
1. Make sure that the monitor is switched to standby.
2. Connect the K-CREMCO to the 5-pin DIN connector X9 that is located on the right side of the
Compact Monitor display unit.
3.5 Anesthesia Record Keeping Keyboard, K-ARKB
To connect Anesthesia Record Keeping Keyboard, K-ARKB to a S/5 Compact Monitor:
1. Make sure that the monitor is switched to standby.
2. Connect the K-ARKB with an appropriate cable to the 5-pin DIN connector X9 that is located
on the right side of the Compact Monitor display unit.
Document No. M1031508
20
Summary of Contents for S/5 Compact Anesthesia Monitor
