DATAPROCESS EUROPE S.p.A.
ST 230 USER MANUAL Pag.
32
Once the selection is made, press the
HEAD LIFT
key and
ON
LINE
key again in order to have the elaboration and the
printout of the desired text.
13.7 MACRO SELECTION
It is possible to insert, in a proper
EPROM
memory, a series of further texts (up to a
maximum of 99) or, generally, command sequences
(MACRO)
in order to
personalise the printer to specific operations. Texts are acceptable by command
via serial line and also by front panel following the here below procedure.
Keep the printer in
OFF-LINE
mode pressing the
ON-
LINE
key (following instruction on paragraph
13.4).Then press sequentially keys
HEAD LIFT,
THERM-TRANSF.
Key
THERM-TRANSF
pressed once, twice, three times permits the selection of
the first, second, third macro text.
Once the selection is made, press the
HEAD LIFT
key and
ON-
LINE
again sequentially in order to have the elaboration and the
printout of the desired text.
13.8 SET- UP OR CONFIGURATION MODE
It is also possible to vary the configuration of the printer from front panel following
the here below instructions.
1. Switch the printer
ON
following the instructions in paragraph 7.1, keeping the
ON-LINE
key pressed till the printer completes the switching on phase in
paragraph 12 and release it after a few seconds when the leds are
ON
for the
second time. All the light leds are off (with the exception of the red one) and the
printer is in configuration mode.
