DATAPROCESS EUROPE S.p.A.
ST 230 USER MANUAL Pag.
35
Pressing
RIBBON ECONOM
again, the selection stops and a test label is printed where
the width of the central zone (black, grey and bars) it adjust to the value given to the
margins always keeping itself centered with respects to the printhead. The adjustment of
margins is of help to avoid any possible ink stains on the rubber roll in case of using
narrower labels compared to the previous label width. In case of using different label
formats it is useful to leave the printer set with margins corresponding to the narrower
one sending time by time from line the correct command on the basis to the text to be
printed. At this point exit from configuration mode (as described in paragraph 13.8) in
order to execute the modifications programmed.
13.12 PRINTING SPEED SELECTION
Select the printer in configuration mode (as described in paragraph 13.8) then
press the
THERM TRANSF
key (the respective led is turn
on). Then press the
FEED
key.
Now, each pression of the
FEED
key the printer chooses
in turn one of the three different pre-set speed (the speed
values are reported on parameter J and are
1204, 1806, 2709 for the 6 dots/mm
and
1105, 1306
2210 for the 8 dots/mm)
, printing a test label each time
to certify the selection result.
Pressing
RIBBON ECONOM
again, the selection stops
and a test label is printed containing the values set. At this point exit from
configuration mode (as described in paragraph 13.8) in order to execute the
modifications programmed.
13.13 PRINTHEAD TEMPERATURE ADJUSTMENT
Select the printer in configuration mode (as described in paragraph 13.8) then
press the
THERM TRANSF
key (the respective led is turn
on).
Concerning the temperature
(printhead power),
the
ON
LINE
key permits a rough adjustment, in turn among
5 pre-
fixed values
for the 6 dots/mm printhead (
4
for the 8
dots/mm printhead) while the
HEAD LIFT
and
RIBBON ECONOM
keys permit a
+ 1 mm
- 1 mm
