Datalogic Gryphon I GPS4400, Product Reference Manual

Page: 83 / 316

Reading Parameters Enter/Exit Programming Mode
Product Reference Guide 73
Aiming Pointer
Enables/disables the aiming pointer for all symbologies.
$CTAAP00(CR)
Aiming Pointer = Disable
$CTAAP01(CR)
Aiming Pointer = Enable
DEFAULT
Aiming Duration Timer
Specifies the time the aiming pointer remains on after decoding a label,
when in On Line or Serial On Line mode.The range for this setting is from 1
to 255 seconds in 1-second increments. See
page 259
in “References”.
DEFAULT
LSTM00
Aiming Off After Decoding
LSTM
Set Aiming Duration Timer
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code , then the bar code at left
followed by the digits from the characters in
Appen-
dix D, Keypad
representing your desired charac-
ter(s). End by scanning the ENTER/EXIT bar code
again.
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start again
at the beginning.
~
CANCEL