Datalogic Gryphon I GPS4400, Product Reference Manual

Page: 67 / 316

Data Format Enter/Exit Programming Mode
Product Reference Guide 57
Match String
This feature allows you to define the string to be used as the match code for
Code Verification. The Match String must be configured to include start/
stop characters and check digits if their transmission is enabled. See "
Match
String" on page 252
in References for more information.
It is possible to define the Match string by inserting:
• all printable characters
• non printable ASCII characters
No wild card characters are supported.
$CCOVS
Set Match String
To configure this feature, scan the ENTER/EXIT PROGRAMMING
MODE barcode above, then the barcode at left followed by the
digits (in hex) from the Alphanumeric characters in
Appen-
dix D on page 289
representing your desired character(s).
End by scanning the ENTER/EXIT barcode again.
Make a mistake? Scan the CANCEL barcode to abort and not
save the entry string. You can then start again at the beginning.
~
CANCEL
Wrong Code String
See "
Wrong Code String" on page 253
in References for more information about
this feature.
$CWCVS
Set Wrong Code String
To configure this feature, scan the ENTER/EXIT PROGRAMMING
MODE barcode above, then the barcode at left followed by the
digits (in hex) from the Alphanumeric characters in
Appen-
dix D on page 289
representing your desired character(s).
End by scanning the ENTER/EXIT barcode again.
Make a mistake? Scan the CANCEL barcode to abort and not
save the entry string. You can then start again at the beginning.
~
CANCEL