Datalogic Gryphon I GPS4400, Product Reference Manual

Page: 21 / 316

Custom Configuration Settings Setup
Product Reference Guide 11
Resetting the Product Configuration to Defaults
Restore Custom Defaults
If you aren’t sure what programming options are in your imager, or you’ve
changed some options and want to restore the Custom Default Configura-
tion that may have been saved in the scanner, scan the Restore Custom
Default Configuration bar code below. This will restore the custom configu-
ration for the currently active interface.
Restore Custom Default Configuration
$P,HA00,P(CR)
Custom defaults are based on the interface type. Configure the imager
for the correct interface before scanning this label.
Restore Factory Configuration
If you want to restore the Factory Configuration for your imager, scan either
the Restore USA Factory Configuration bar code or the Restore EU Factory
Configuration bar code below. Both labels restore the scanner configuration
to the factory settings, including the interface type. The USA label restores
Label IDs to those historically used in the USA. The EU label restores Label
IDs to those historically used in Europe. The Label ID sets for USA and EU
are shown in the
Label ID Control
on page 49 of this manual.
$P,AE,P(CR)
Restore USA Factory Configuration
$P,Ae,P(CR)
Restore EU Factory Configuration
The programming items listed in the following sections show the factory
default settings for each of the menu commands.