Datalogic Gryphon I GPS4400, Product Reference Manual

Page: 259 / 316

Data Editing References
Product Reference Guide 249
Label ID: Set Individually Per Symbology
To configure a Label ID individually for a single symbology:
1. Go to
page 49
and scan the ENTER/EXIT bar code.
2. Select Label ID position as either BEFORE (Enable as Prefix) or AFTER
(Enable as suffix) by scanning the appropriate bar code in the section
"Label ID Control"
on page 49. Reference Figure 6 for Label ID positioning
options if multiple identification features are enabled.
3. Scan a bar code to select the symbology for which you wish to config-
ure a custom Label ID from the section
"Label ID Symbology Selection − 1D
Symbologies"
on page 50.
4. Determine the desired character(s) (you may choose up to three) which
will represent the Label ID for the selected symbology.
5. Turn to the
ASCII Chart
on the inside back cover of this manual and find
the equivalent hex digits associated with your choice of Label ID. For
example, if you wish to select an equal sign (=) as a Label ID, the chart
indicates its associated hex characters as 3D. Turn to
Keypad, starting on
page 289
and scan the bar codes representing the hex characters deter-
mined. For the example given, the characters ‘3’ and ‘D’ would be
scanned. More examples of Label ID settings are provided in
Table 34
.
If you make a mistake before the last character, scan the CANCEL bar
code to abort and not save the entry string. You can then start again
at the beginning.
6. Scan the ENTER/EXIT bar code to exit Label ID entry.
7. Scan the ENTER/EXIT bar code once again to exit Programming Mode.
Figure 6. Label ID Position Options
OR
Prefix S u ffix L ab el ID L ab el ID B a r Code D a t a Aim ID