Datalogic Gryphon I GPS4400, Product Reference Manual

Page: 201 / 316

2D Symbologies Enter/Exit Programming Mode
Product Reference Guide 191
Micro PDF417 Length Control
This feature specifies either variable length decoding or fixed length decod-
ing for this symbology.
Variable Length:
For variable length decoding, a minimum and maximum
length may be set.
Fixed Length:
For fixed length decoding, two different lengths may be set.
DEFAULT
$CMILC00(CR)
Micro PDF417 Length Control = Variable Length
$CMILC01(CR)
Micro PDF417 Length Control = Fixed Length
Micro PDF417 Set Length 1
Specifies one of the bar code lengths for
Micro PDF417 Length Control
. Length
1 is the minimum label length if in
Variable Length
Mode, or the first fixed
length if in Fixed Length Mode. Length includes the bar code’s data charac-
ters only. Characters can be set from 0001 to 0366 characters (pad with
zeros) in increments of 01. Any value greater than 0366 will be considered
to be 0366. See
page 241
for detailed instructions on setting this feature.
$CMIL1
Select Micro PDF417 Length 1 Setting
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code
at left followed by the digits from the Alphanumeric
characters in
Appendix D, Keypad
representing your
desired character(s). End by scanning the ENTER/EXIT
bar code again.
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start again
at the beginning.
~
CANCEL
DEFAULT
0001 = Length 1 is 1 Character