Datalogic Gryphon I GPS4400, Product Reference Manual

Page: 72 / 316

Enter/Exit Programming Mode Reading Parameters
62 Gryphon™ GPS4400
Double Read Timeout
Double Read Timeout specifies the minimum time between consecutive
good reads of labels of the same symbology and data. This prevents a dou-
ble read of the same label. If the unit reads a label and sees the same label
again within the specified timeout, the second read is ignored. Double Read
Timeout does not apply to scan modes that require a trigger pull for each
label read. The timeout can be set within a range of 20 milliseconds to
2,550 milliseconds (2.55 seconds) in 10ms increments.
$CSNDR0A(CR)
Double Read Timeout = 0.1 Second
$CSNDR32(CR)
Double Read Timeout = 0.5 Second
$CSNDR64(CR)
Double Read Timeout = 1 Second
DEFAULT
To specify your own setting, scan the bar code below followed by the
appropriate characters from
Appendix D, Keypad
. See
page 254
in “Ref-
erences” for detailed instructions and examples for setting this feature.
$CSNDR
Select Double Read Timeout Setting
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start again
at the beginning.
~
CANCEL