Data Display Group ArtistaMEDIA PA-09 Series, Manual

Page: 37 / 49

DATA DISPLAY GROUP
Manual

Press the reload button of your Browser to get the home page of the ArtistaMEDIA Web
Frontend in normal operating mode

Select the menu “ System Information ” and verify, that the “ Filesystem Version ” has the
new version number now

Firmware update has been finished successfully then
12 Network Factory Default Values
ArtistaMEDIA has the following network factory default values. These values are used on delivery
of the ArtistaMEDIA boards and remain until the user re-configures them by using the Web
Frontend.
NOTE:
Dynamic network configuration (DHCP) is disabled by default.

DHCP: disabled

Static IP address of the ArtistaMEDIA board: 192.168.0.1

Subnet mask: 255.255.255.0

Gateway: 192.168.0.100

Password for Web Frontend: Artista

ACC upload control port: 28243

ACC upload data port: 1024
ArtistaMEDIA can be reset to these values by using the procedure described in section
Reset
ArtistaMEDIA to Network Factory Default Values .
13 Reset ArtistaMEDIA to Network Factory Default Values
If you want to reset the network configuration of your ArtistaMEDIA board to the factory defaults
mentioned in section
Network Factory Default Values (e.g. because you don’t know the IP address
of your ArtistaMEDIA board and can not access it via the Web Frontend any more), you have to
execute the following steps:

Power down ArtistaMEDIA

Pull down the factory reset pin (CON18, Pin 9) to Ground level and power up ArtistaMEDIA
again

Keep the pin pulled down until both LEDs LED6 and LED7 are flashing once. This is about 10
seconds after powering on the board. Now the pin can be released again

ArtistaMEDIA will boot in Maintenance Mode now by using the network default values. In
maintenance mode the video playback is deactivated and the panel will stay black

Access the ArtistaMEDIA board via the Web Frontend by using the IP address 192.168.0.1

Enter the menu “ Network Configuration ” and enter a proper network configuration for
your ArtistaMEDIA board. Press “ Submit Configuration ” to save the new settings

Select the menu “ Restart Artista ” and press the button “ Enter Normal Operating Mode ”

ArtistaMEDIA will boot in normal operating mode now and will start playing back the
playlist again, if there is one available on the internal storage
ArtistaMEDIA
Version 1.12
05.10.2011
Page 37 of 49