95
5.0 UPC Types
5.14.1
Decode Event :
Parameter # 0xF0 0x00
When enabled, the decoder generates a message to the host whenever a
bar code is successfully decoded. When disabled, no notification is sent.
5.14.2
Boot Up Event :
Parameter # 0xF0 0x02
When enabled, the decoder sends a message to the host whenever power
is applied. When disabled, no message is sent.
*Disable
(0x00)
*Disable
(0x00)
Enable
(0x01)
Enable
(0x01)
5.14 Event Reporting
The host can request the decoder to furnish certain information (events)
relative to the decoder’s behavior. Enable or disable the events listed in
Table 8-2 by scanning the appropriate bar codes on the following pages.
Parameter number format for these parameters follows those shown in
Table 9-9 on page 9-20 for parameters numbered 256 or higher.
Event Class
Event
Code Reported
Decode Event
Non parameter decode
0x01
Boot Up Event
System power-up
0x03
Parameter
Event
Parameter entry error
Parameter stored
Defaults set (and parameter
event is enabled by default)
Number expected
0x07
0x08
0x0A
0x0F
5.14.3
Parameter Event :
Parameter # 0xF0 0x03
When enabled, the decoder sends a message to the host when one of
the events specified in the table in
Section 5.14
above occurs. When
disabled, no message is sent.
*Disable
(0x00)
Enable
(0x01)
5.15 Numeric Bar Codes
For parameters requiring specific numeric values, scan the appropri-
ately numbered bar code(s).
0
1
2
3
4
5
6
8
7
9
5.15.1 Cancel
To change the selection or cancel an incorrect entry, scan the bar code
below.
Cancel