DT-50 and DT-50A Tire Changer
44
P/N 5900260 — Rev. A1 — Dec. 2020
for few seconds to move the Turntable counterclockwise, then press down again to
move clockwise. Repeat as necessary to clear up the difficulty.
Watch the top Bead to make sure it is being pushed over the Rim, all the way around the Tire, as
the Turntable moves.
Keep turning the Turntable until the entire top Bead pops over the top of the Rim.
When the top Tire Bead pops over the Rim, release the Turntable Foot Pedal and remove the Bead
Lifting Tool.
The top Bead is demounted.
The next step is to demount the bottom Bead over the top Rim.
Make sure there is still lubricant on the bottom Bead and the top Rim.
If there is not, put some more on.
Push the bottom Bead up as much as possible all the way around the Wheel, then push the side of
the Tire opposite the Mount/Demount Head into the Drop Center of the Wheel.
Take the Bead Lifting Tool, put it on the outside of the Demount Lip, then slide it down past and
under the bottom Bead.
Side view. Not to scale.
Getting the Bead Lifting Tool into position may be trickier this time, as the rest of the Tire is in the
way as you are trying to get access to the bottom Bead.
Side view. Not to scale.
Summary of Contents for DT-50
