DT-50 and DT-50A Tire Changer
17
P/N 5900260 — Rev. A1 — Dec. 2020
Installing the Assist Tower and Arm (DT-50A Only)
IMPORTANT
Dannmar strongly recommends having a second person help install the Assist
Tower and Arm.
⚠
WARNING
Use care when moving the Assist Tower and Arm. It is heavy and not evenly
balanced. If it is dropped, you could injure bystanders and damage the unit.
To install the Assist Tower and Arm
:
This section applies to the DT-50A only.
Refer to the
Dannmar strongly recommends having a second person help install the Assist Tower and Arm.
Make sure you are wearing OSHA-approved (publication 3151) Personal Protective Equipment:
leather gloves, steel-toed work boots, back belts, hearing protection, and ANSI-approved eye
protection (safety glasses, face shield, or goggles).
Carefully
remove the components that secured the Assist Tower and Arm during transport.
Have one person hold the Assist Arm and Tower while you guide the Arm in position over the Pivot
Pin on the Tower, as shown below.
Slide on the Washer then thread on the top and bottom lock nuts on the Pivot Pin.
Adjust the motion of the arm by tightening the bottom lock nut until the arm can move freely, but is
not so tight as to require significant force to move.
Tighten the top locknut to lock the bottom locknut in position.
View not to scale, not all components shown.
Summary of Contents for DT-50
