Dannmar DT-50, Installation And Operation Manual

Page: 27 / 84

DT-50 and DT-50A Tire Changer
27
P/N 5900260 — Rev. A1 — Dec. 2020
To clamp externally
: If necessary, press Up on the Clamps Foot Pedal to move the Clamps
out
. The clamps may be all the way out already, in which case you do not need to move them.
Then, position the Wheel between the Clamps and press Down on the Clamps Foot Pedal to
move the Clamps In until the Wheel is being held firmly on the Turntable.
To clamp internally
: If necessary, press Down on the Clamps Foot Pedal to move the Clamps
In
The clamps may be all the way in already, in which case you do not need to move them.
Then, position the Wheel over the Clamps and press Up on the Clamps Foot Pedal to move the
Clamps Out until the Wheel is being held firmly on the Turntable.
Pedal Function
The Tire Changer has Three Foot Pedals that control the Tire Changer actions:
•
Turntable Foot Pedals rotate the Turntable. Press and hold Down the Turntable Foot Pedal to
rotate clockwise, press
and hold Up
the Turntable Foot Pedal to rotate counter-clockwise. When
you release the Turntable Foot Pedal, the Turntable stops moving.
• Clamps Foot Pedal .
Press and hold
Down to move the Clamp Mechanisms inward towards the
center of the turntable.
Press and hold
Up to move the clamps outwards away from the center of
the turntable.
• Bead Breaker Foot Pedal .
Press and hold
Down to move the Bead Breaker Blade in toward
the Tire Changer. Release the pedal to move the Blade back out.
The Bead Breaker Blade has a limited range of motion. At some point, it will not move any further
in toward the Tire Changer. You should release the Bread Breaker Foot Pedal when this happens,
whether the Bead is broken or not.
Front view. Not to scale. Not all components shown.