1.1.1 Copyright, Limitation of Liability and
Revision Rights
This publication contains information proprietary to Danfoss.
By accepting and using this manual the user agrees that the
information contained herein will be used solely for
operating equipment from Danfoss or equipment from other
vendors provided that such equipment is intended for
communication with Danfoss equipment over a serial
communication link. This publication is protected under the
Copyright laws of Denmark and most other countries.
Danfoss does not warrant that a software program produced
according to the guidelines provided in this manual will
function properly in every physical, hardware or software
environment.
Although Danfoss has tested and reviewed the documen-
tation within this manual, Danfoss makes no warranty or
representation, neither expressed nor implied, with respect
to this documentation, including its quality, performance, or
fitness for a particular purpose.
In no event shall Danfoss be liable for direct, indirect, special,
incidental, or consequential damages arising out of the use,
or the inability to use information contained in this manual,
even if advised of the possibility of such damages. In
particular, Danfoss is not responsible for any costs, including
but not limited to those incurred as a result of lost profits or
revenue, loss or damage of equipment, loss of computer
programs, loss of data, the costs to substitute these, or any
claims by third parties.
Danfoss reserves the right to revise this publication at any
time and to make changes to its contents without prior
notice or any obligation to notify former or present users of
such revisions or changes.
1.1.2 Approvals
1.1.3 Symbols
Symbols used in this guide.
NOTE
Indicates something to be noted by the reader.
CAUTION
Indicates a potentially hazardous situation which, if not
avoided, may result in minor or moderate injury or
equipment damage.
WARNING
Indicates a potentially hazardous situation which, if not
avoided, could result in death or serious injury.
*
Indicates default setting
Introduction
VLT
®
HVAC Drive Programming Guide
4
MG.11.CB.02 - VLT
®
is a registered Danfoss trademark
1
1
