Danfoss VLT HVAC Drive FC 100 Series, Programming Manual, Page: 19 / 122

No & Name Range Default Function
1-22 Motor Voltage 50.0–1,000.0 V Size related Enter motor voltage from nameplate data
1-23 Motor Frequency 20.0–400.0 Hz Size related Enter motor frequency from nameplate data
1-24 Motor Current 0.01–10,000.00 A Size related Enter motor current from nameplate data
1-25 Motor Nominal
Speed 100.0–9,999.0 RPM Size related Enter motor nominal speed from nameplate data
1-26 Motor Cont. Rated
Torque 0.1–1,000.0 Size related This parameter is available only when 1-10 Motor
Construction Design is set to
[1] PM, non-salient
SPM .
NOTE!
Changing this parameter will affect settings
of other parameters
1-29 Automatic Motor
Adaption (AMA) See 1-29 Automatic Motor Adaption
(AMA)
Off Performing an AMA optimizes motor performance.
1-30 Stator Resistance
(Rs) 0.000–99.990 Size related Set the stator resistance value
1-37 d-axis Inductance
(Ld) 0–1000 Size related Enter the value of the d-axis inductance.
Obtain the value from the permanent magnet
motor data sheet. The de-axis inductance cannot
be found by performing an AMA.
1-39 Motor Poles 2-100 4 Enter the number of motor poles
1-40 Back EMF at 1000
RPM 10–9,000 Size related Line-Line RMS back EMF voltage at 1000 RPM
1-73 Flying Start When PM is selected, Flying Start is enabled and
cannot disable
1-73 Flying Start [0] Disabled
[1] Enabled 0 Select [1] Enable to enable the drive to catch a
motor spinning due to line drop-out. Select [0]
Disable if this function is not required. When is
enabled 1-71 Start Delay and 1-72 Start Function
have no function. is active in VVC+ mode only.
3-02 Minimum Reference -4,999-4,999 0 The minimum reference is the lowest value
obtainable by summing all references.
3-03 Maximum Reference -4,999–4,999 50 The maximum reference is the lowest obtainable
by summing all references.
3-41 Ramp 1 Ramp Up
Time 0.05–3,600.0 s Size related Ramp-up time from 0 to rated 1-23 Motor
Frequency if Asynchron motor is selected; ramp-up
time from 0 to 1-25 Motor Nominal Speed if PM
motor is selected
3-42 Ramp 1 Ramp
Down Time 0.05–3,600.0 s Size related Ramp-down time from rated 1-23 Motor
Frequency to 0 if Asynchron motor is selected;
ramp-down time from 1-25 Motor Nominal Speed
to 0 if PM motor is selected
4-12 Motor Speed Low
Limit [Hz] 0.0–400 Hz 0 Hz Enter the minimum limit for low speed
4-14 Motor Speed High
Limit [Hz] 0.0–400 Hz 65 Hz Enter the maximum limit for high speed
4-19 Max Output
Frequency 0–400 Size related Enter the maximum output frequency value
5-40 Function Relay [0]
Function relay See 5-40 Function Relay Alarm Select the function to control output relay 1.
5-40 Function Relay [1]
Function relay See 5-40 Function Relay Drive running Select the function to control output relay 2.
How to Program
VLT
®
HVAC Basic Drive Programming Guide
MG18B222 - VLT
®
is a registered Danfoss trademark 2-5
2 2