2
Safety
2.1
Safety
When designing AC drives, some residual dangers cannot be avoided. One example is the discharge time, which must be observed to
avoid potential death or serious injury. The discharge time is shown on the danger label on the drive.
For further information on safety precautions related to the installation, operation, or maintenance of products, refer to the product-
specific installation, safety, and operating guides.
2.2
Safety Symbols
The following symbols are used in Danfoss documentation.
DANGER
Indicates a hazardous situation which, if not avoided, will result in death or serious injury.
WARNING
Indicates a hazardous situation which, if not avoided, could result in death or serious injury.
CAUTION
Indicates a hazardous situation which, if not avoided, could result in minor or moderate injury.
NOTICE
Indicates information considered important, but not hazard-related (for example, messages relating to property damage).
The guide also includes ISO warning symbols related to hot surfaces and burn hazard, high voltage and electrical shock, and referring to
the instructions.
ISO warning symbol for hot surfaces and burn hazard
ISO warning symbol for high voltage and electrical shock
ISO action symbol for referring to the instructions
2.3
General Safety Considerations
WARNING
LACK OF SAFETY AWARENESS
This guide provides important information on preventing injury and damage to the equipment or the system.
Ignoring this information can lead to death, serious injury, or severe damage to the equipment.
l
Make sure to fully understand the dangers and safety measures present in the application.
12
| Danfoss Drives Oy © 2024.03 AJ389643111587en-000101 / 172F6361A
Design Guide | iC7 Series Air-cooled System Modules