© Danfoss 05-2011
AK-EM 100 Installation Guide
8
RC8BX402
1.3.3 Adding a System Manager gateway
To add a System Manager gateway, press the ‘New’ button.
The available options for entry are:
Name
- Again, the name will increment e.g. MPH-02 etc.
Gateway Type
- Select System Manager from the drop down menu.
Language
- Select the language. When selected, it will be the language which will be displayed
throughout the whole site as it searches for the language within the DES file.
Destination
- Enter the Destination name.
Does not need to be added if Connection Type is Serial.
Pass Code
- Enter a password to allow you to connect to the SM.
Does not need to be added if Connection Type is Serial.
NOTE: Matching destination and pass code must be configured in the System Manager.
IP number:port
- Add the IP address and port number.
Does not need to be added if Connection Type is Serial.
Connection Type
- Choose a connection type, either ethernet or serial port. Whatever is selected will
be shown in the Name’s title. If a gateway is already being used on serial port1, then the only available
option will be ethernet.
Fields that are greyed out are not required; whereas pink fields are required.
When finished, press the ‘Save’ button to store the it.
Advanced Options
This option only applies to the System Manager gateway and is a means of viewing the System Manager’s
Service Tool on the Unix server. This allows you to access the SM remotely, and make any necessary
changes. Follow the on-screen instructions to connect and refer to the Service Tool manual for more
information.
1.3.4 Deleting Gateways
Gateways can be deleted so long as they are not connected to the controllers.
1. Scroll through to the desired gateway
2. Make sure that there are no connections to any controllers by stopping the network uploads or
communications (see next section). Then press the ‘Delete’ button.
