Dalsa Genie Nano-CXP Series, User Manual

Page: 38 / 107

36
•
Operational Reference Genie Nano-CXP Series™
T rigger Delay T riggerDelay
Specifies the delay in microseconds to apply after
rec eiving the trigger and before activating the
triggerEvent.
1 .0 0
Beginner
T rigger Overlap T riggerOverlap
States if a trigger overlap is permitted with the Active
Frame readout signal. T his feature defines if a new valid
trigger will be accepted (or latched) for a new frame.
1 .0 0
Guru
Off Off No trigger overlap is permitted.
ReadOut ReadOut Trigger is accepted immediately after the start of the
readout.
End Of Expos ure EndOfExposure Trigger is accepted immediately after the previous
expos ure period. This will latch the Trigger and delay the
Expos ure if the end of that expos ure is s horter than the
previous readout.
Line Selector LineSelector
Selects the physical line (or pin) of the external device
c onnector to c onfigure.
1 .0 0
Beginner
CXP_AVAILABLE CXP Select the Coaxpres s trigger.
Line N ame lineName
Description of the physical Pin associated with the logical
line.
1 .0 0
Beginner
DFN C
Coaxpres s Line CXP As s ociated with Coaxpres s line trigger
Input 1 Input1 As s ociated with the logical line Input 1
Input 2 Input2 As s ociated with the logical line Input 2
Output 1 Output1 As s ociated with the logical line Output 1
Output 2 Output2 As s ociated with the logical line Output 2
Line Status LineStatus
Returns the c urrent s tatus of the selected input or output
line.
1 .0 0
E xpert
Fals e The Line is logic LOW
True The Line is logic HIGH
Line Status All LineStatusAll
Returns the c urrent s tatus of all available line s ignals, at
time of polling, in a s ingle bitfield. T he order is Line1,
Line2, Line3, ...
1 .0 0
E xpert
Line Inverter LineInverter
C ontrol to invert the polarity of the selected input or
output line s ignal.
1 .0 0
Beginner
Fals e / True
Input Line Debouncing
P eriod
lineDebouncingPeriod
Specifies the minimum delay before an input line voltage
trans ition is recognizing as a s ignal transition.
1 .0 0
Beginner
DFN C
Line Format LineFormat
Specify the c urrent electrical format of the s elected
phys ical input or output.
1 .0 0
Invis ible
LVDS LVDS The line accepts LVDS level s ignals.
Opto-Coupled OptoCoupled The line is opto-Coupled.
Line Mode LineMode Reports if the physical Line is an Input or Output s ignal..
1 .0 0
Invis ible
Input Input The line is an input line.
Output Output The line is an output line.
Input Line Detection Level lineDetectionLevel
Specifies the voltage threshold required to recognize a
s ignal transition on an input line.
1 .0 0
Invis ible
DFN C
Thres hold for TTL Thres hold_for_TTL A signal below 0.8V will be detected as a Logical LOW and
a s ignal greater than 2.4V will be detected as a Logical
HIGH on the s elected input line.