Dalsa Genie Nano-CXP Series, User Manual

Page: 37 / 107

Genie Nano-CXP Series™ Operational Reference
•
35
I/O Control Feature Descriptions
The following table describes these features along with their view attribute and minimum firmware
version required. Additionally the Device Version column will indicate which parameter is a member
of the DALSA Features Naming Convention (indicated by DFNC), versus the GenICam Standard
Features Naming Convention (SFNC tag is not shown).
The Device Version number represents the camera software version, not a firmware revision
number. New features for a major device version release will be indicated by green text for easy
identification.
Display Nam e Feature & Values Description Device
Version
& View
T rigger Selector T riggerSelector
Selects which type of trigger to configure with the various
T rigger features.
1 .0 0
Beginner
Single Frame Trigger(Start) FrameStart Selects a trigger starting the capture of a single frame.
Frame s ize is determined by image format feature
“Height”.
MultiFrame Trigger(Start) FrameBurs tStart Selects a trigger to capture multiple frames. The number
of frames is specified by the “triggerFrameCount” feature.
T rigger M ode T riggerMode C ontrols the enable state of the selected trigger.
1 .0 0
Beginner
Off Off The s elected trigger is turned off.
On On The s elected trigger is turned active.
T rigger Frames Count triggerFrameCount
Sets the total number of frames to acquire when a valid
trigger is received. This feature is available when Trigger
Selector = M ultiFrame T rigger(Start).
1 .0 0
DFN C
Beginner
Software T rigger T riggerSoftware
Generate a s oftware command internal trigger
immediately no matter what the T riggerSource feature is
s et to.
1 .0 0
Beginner
T rigger Source T riggerSource
Specifies the internal signal or physical input line to use
as the trigger source. The s elected trigger must have its
T riggerMode set to ON.
1 .0 0
Beginner
CXP CXP Select CXP trigger (and associated I/O control block) to
us e as the external trigger s ource. See LineSelector
feature for complete list.
Software Software The trigger command source is only generated by
s oftware using the Trigger Software command.
Timer1End Event Timer1End Select the TimerEnd Event as the internal trigger s ource.
Counter1End Event Counter1End Select the CounterEnd Event as the internal trigger
s ource.
T rigger Input Line Activation T riggerActivation
Select the activation mode for the s elected Input Line
trigger source. T his is applicable only for external line
inputs.
1 .0 0
Beginner
Ris ing Edge Ris ingEdge The trigger is considered valid on the rising edge of the
line s ource s ignal (after any processing by the line
inverter module).
Falling Edge FallingEdge The trigger is considered valid on the falling edge of the
line s ource s ignal (after any processing by the line
inverter module).
Any Edge AnyEdge The trigger is considered valid on any edge of the line
s ource s ignal (after any processing by the line inverter
module).
Level High LevelHigh The trigger is considered valid on the high level of the
line s ource s ignal.
Level Low LevelLow The trigger is considered valid on the low level of the line
s ource s ignal.