Daktronics All Sport 5000, Operation Manual

Page: 46 / 416

Basic Operations 29
Multiple Controller w/Single Broadcast Group Channel Setting
Typically all single controller systems will use Broadcast 1 and Channel 1 for the first
controller and Channels 2-8 for all remaining controllers. All radio receivers must be set with
a switch setting corresponding to the console controlling the scoreboard and a Broadcast 1
(BCAST 1) jumper set.
If you suspect interference from a nearby Daktronics system, press <
CLEAR
> at the “ RADIO
SETTINGS ” prompt to change the channel number.
Typically all multiple controller systems will use channel 1 for the first controller. All other
controllers will use sequential channel settings (2-8). The following table describes broadcast
group and channel settings.
LCD Display Action
The LCD will toggle
these screens
The bottom line shows
default settings .
RADIO SETTINGS
BCAST Y CHAN XX
Enter to accept
Clear to modify
bcast group 1
radio chan 01
The LCD shows the current radio settings along
with a prompt to accept or modify these values.
If the radio settings are correct press < ENTER >.
If these values are incorrect press < CLEAR >
If < CLEAR > is pressed to modify the radio settings
the LCD at the left is shown, allowing edit of the
channel or broadcast group setting.
To edit the broadcast setting, use the number keys
to enter the desired broadcast group and press
< ENTER > to accept.
Broadcast Group Setting
1- Use this setting for all multiple controller
with single broadcast group setups. The
asterisk will move to the channel setting.
Use the number keys to edit this value and
press < ENTER > to accept. Edit the
channel number to the desired value and
press < ENTER > to accept.
Channel Setting
1-8 Channels that may be used with broadcast
channel 1. The channel switch on the
receiver must match this value and only the
Broadcast 1 (BCAST1) jumper must be
installed.