Daktronics All Sport 5000, Operation Manual

Page: 194 / 416

Track Operations 177
Section 12: Track Operations
Sport Insert: LL-2439
The Sport Insert drawing is located at the end of this section. The Team Name insert and Block
Diagram drawings are located in
Appendix A . The Quick Reference is located in Appendix D .
Reference Drawings:
Block Diagrams, A/S5000/3000, Outdoor Sports ............................................... Drawing A-124690
Insert, Track ........................................................................................................ Drawing A-125094
Insert, Team Name ............................................................................................. Drawing A-125290
Refer to the information in Section 2 to start up the console and use the sport insert. Read Section 2
carefully to fully understand the following operation instructions.
If an insert is lost or damaged, a copy of the insert drawing located at the end of this section can be
used until a replacement can be ordered.
Use the labels provided in Appendix B to attach the correct code number label to the sport insert in
the appropriate location. Write the code number in the space provided below.
Write the correct code number here.
Notes: The four-digit code displayed is the code that is currently selected. Code 8601
is the code for manual data input.
External Timer Codes 8602 - 8604
•
External timers must have specific Baud rates entered into the Venus
®
7000
computer when using RTD information. The different rates are noted with
each external timer.
•
Code 8602 is for interfacing with the PowerTime timer.
•
The Scoreboard type setting in the PowerTime under
initialization/scoreboard/type must be set to multi-line and 1. The baud rate
must be changed to 9600 in the Venus 7000 computer.
•
Code 8603 is for interfacing with the OmniSport
®
1000 or OmniSport 6000.
•
The “Current Loop Scoreboard Setting” under Setup / Comm. Ports on the
OmniSport 6000 must be set to “SW-87/89, MS-167/169” if code 8603 is used
with the OmniSport 6000 track timing program. The baud rate must be set to
12800 Baud in the Venus 7000 computer.
•
Code 8604 is for interfacing with Hawkeye or Finish Lynx timers .
The Baud rate for the Hawkeye and Finish Lynx timers must be set to 9600
Baud.