Daikin R407C PLUS, Service Manual

Page: 123 / 267

Test Operation Si33-105
112 Test Operation R407C PLUS Series Heat Recovery System
1.4.2 Setting Mode 2
To switch from setting mode 1 (normal) to setting mode 2, you must push and hold the next
page button (BS1) for 5 seconds. (You cannot enter setting mode 2 while setting mode 1 is set.)
Setting
Procedure 1. Push the SET button and match with the setting item (LED display). (All 10 settings)
'
2. Push the RETURN button (BS3) and the present settings flicker (LED display).
'
3. Push the SET button (BS2) and match with each setting (LED flicker display).
'
4. Push the RETURN button (BS3) and enter the settings.
'
5. Push the RETURN button (BS3) and return to the initial status.
Note: 1. If you become unsure of how to proceed, push the MODE button (BS1) and return to setting
mode 1.
2. The initial status of setting mode 2 is the status of setting item No. 1 in mode 2.
Setting Items
Emergency operation
(Operates by constant speed outdoor unit only.)
Normal operation
No Setting item Description
LED display
H1P H2P H3P H4P H5P H6P H7P
Emergency operation
when inverter type
outdoor unit malfunctions. EMG
(Emergency
operation 1) 0
LED display
H1P H2P H3P H4P H5P H6P H7P
3 units
2 units
1 unit
Address for
sequential start
system. Sequential
start system
address 3
Outdoor unit for
sequential start. Number of unit
for sequential
start 4
Address 0
Binary number 1
(5 digits) 2
31
Address for cool/heat
unified operation. Cool/heat
unified
address
Do not set.
1
~
Address 0
Binary number 1
(5 digits) 2
31
Address for low
noise / demand
operation. Low noise /
demand
address 2
~
Address 0
Binary number 1
(5 digits) 2
31
~
High
Normal (factory set)
Low
Quick defrost
Normal (factory set)
Slow defrost
Temperature setting
for defrost. Defrost
setting 10
Note 1
Note 1
Forced fan operation
(H tap)
Normal operation Indoor unit fan turns
while unit is stopped. Forced fan
switch 5
Indoor unit forced
operation
Normal operation Allows operation of
indoor unit from
outdoor unit. Indoor unit
forced
operation 6
Low pressure setting
for cooling. TE setting 8
High pressure setting
for heating. TC setting 9
(V0840)