Dahua DHI-ARC3008C, User Manual, Page: 83 / 137

User’s Manual
72
Submenu Setting
TYPE
●
If select AREA in CATEGORIES , then you can select an event from the
following. When the selected event is triggered, the 2G/4G module
will make a voice call to the chosen telephone number.
◇
SYSTEM TAMPER
◇
SIREN TAMPER
◇
ALARM MEMORY
◇
FIRE
◇
PANIC
◇
ROBBERY
◇
MEDICAL
◇
DURESS
●
If select ZONE in CATEGORIES , configure the following settings:
◇
LINK OUTPUT
By selecting the Output (01 to 40) with which the desired events
have been associated in advance, a specific non pre-programmed
call is set. For example, if vocal message 3 was to be used for the
wired zones 1 and 2 alarm, to achieve this, you need to program a
controller
OUTPUT in advance (even if the output module is not
present on the bus) which follows the zone condition for the zone
alarm type which is associated with the wire zones 1 and 2.
Output 3 could be programmed in this way. On the
VOCAL
MESSAGE
menu, a message would then need to be created to
follow the zone event and output 3. In the event of an alarm in
wired zone 1 and 2, vocal message 3 would then automatically
sent the alarm voice call to the programmed telephone numbers.
◇
TEL NO
Select telephone number(s) that you want the vocal message to
link.
●
If you select
SYSTEM
in
CATEGORIES
, then you can select an event
from the following. When the selected event is triggered, it links the
vocal message.
◇
BatteryLow
◇
ACAlarm
◇
BatteryLoss
◇
PSTNBreak
◇
GSMFault
◇
KeypadFailure
◇
KeypadTamper
◇
ModuleLost
Step 5 Press to return to the VOCAL MESSGAES menu.
Then you can continue with programming other vocal messages (up to 88), or press o
return to the VOCAL MESSGAES menu from where you can press and to move to