![background image](http://html1.mh-extra.com/html/daelim/daystar-vl125e/daystar-vl125e_service-manual_3160189193.webp)
15-4
Rear Wheel/Rear Brake/Suspension
Check the teeth of the final driven sprocket.
Replace the worn, damaged final driven
sprocket.
Check the drive chain and drive sprocket at the
same time.
Check the damper rubber. Replace the faulty,
damaged, worn damper rubber.
Remove the dust seal if it is damaged.
Disassembly
Remove the snap ring and final driven sprocket.
Do not disassemble unless replacement.
Bearing Replacement
Install the bearing remover into the bearing.
Install the bearing remover shaft at th opposite
position, and remove the wheel bearing by
heating with a hammer.
After removing the distance collar, remove the
other bearing.
When taking off the wheel bearding, must be
replaced with the new one.
Tools:
Bearing remover shaft
Remover head
NOTE
NOTE
Driven Sprocket
Driven Sprocket
Driven Sprocket
Driven Sprocket
Driven Sprocket
Driven Sprocket
Driven Sprocket
Driven Sprocket
Driven Sprocket
Driven Sprocket
Driven Sprocket
Driven Sprocket
Driven Sprocket
Snap Ring
Snap Ring
Snap Ring
Snap Ring
Snap Ring
Snap Ring
Snap Ring
Snap Ring
Snap Ring
Snap Ring
Snap Ring
Snap Ring
Snap Ring
Good
Bad
Damper Rubber
Damper Rubber
Damper Rubber
Damper Rubber
Damper Rubber
Damper Rubber
Damper Rubber
Damper Rubber
Damper Rubber
Damper Rubber
Damper Rubber
Damper Rubber
Damper Rubber
Damper Rubber
Damper Rubber
Damper Rubber
Damper Rubber
Damper Rubber
Damper Rubber
Damper Rubber
Damper Rubber
Damper Rubber
Damper Rubber
Damper Rubber
Damper Rubber
Damper Rubber
Dust Seal
Dust Seal
Dust Seal
Dust Seal
Dust Seal
Dust Seal
Dust Seal
Dust Seal
Dust Seal
Dust Seal
Dust Seal
Dust Seal
Dust Seal
!
WARNING
Summary of Contents for DAYSTAR VL125E
