D-Link xStack DGS-3612G series, Cli Manual

Page: 426 / 493

xStack
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
423
57
LLDP C
OMMANDS
The LLDP commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the following table.
The Link Layer Discovery Protocol (LLDP) specified in this standard allows stations attached to an 802 LAN to advertise to other
stations attached to the same 802 LAN the connectivity and management information necessary to identify to those management
entities the station's point of attachment to the 802 LAN. The information distributed via this protocol is stored by its recipients in a
standard management information base (MIB), making it possible for the information to be accessed by a network management
system (NMS) using a management protocol such as the Simple Network Management Protocol (SNMP)
Command Parameters
enable lldp
disable lldp
config lldp message_tx_interval <sec 5-32768>
config lldp message_tx_hold_multiplier <int 2–10>
config lldp tx_delay <sec 1-8192>
config lldp reinit_delay <sec 1-10>
config lldp notification_interval <sec 5-3600>
config lldp ports [<portlist>|all] notification [enable | disable]
config lldp ports [<portlist>|all] admin_status [tx_only | rx_only | tx_and_rx |
disable]
config lldp ports [<portlist>|all] mgt_addr [ipv4 <ipaddr> | ipv6 <ipv6addr>] [enable
| disable]
config lldp ports [<portlist>|all] basic_tlvs [all | {port_description | system_name |
system_description | system_capabilities}] [enable | disable]
config lldp ports [<portlist>|all] dot1_tlv_pvid [enable | disable]
config lldp ports [<portlist>|all] dot1_tlv_protocol_vid [vlan [all | <vlan_name 32> ] |
vlanid <vid_list> ] [enable | disable]
config lldp ports [<portlist>|all] dot1_tlv_vlan_name [vlan [all | <vlan_name 32> ] |
vlanid <vid_list> ] [enable | disable]
config lldp ports [<portlist>|all] dot1_tlv_ protocol_identity[all | { eapol | lacp | gvrp |
stp}] [enable | disable]
config lldp ports [<portlist>|all] dot3_tlvs [all | {mac_phy_configuration_status | link
aggregation | maximum_frame_size}] [enable | disable]
config lldp forward_message [enable | disable]
show lldp
show lldp mgt_addr {[ipv4 <ipaddr> | ipv6 <ipv6addr>]}
show lldp ports {<portlist>}
show lldp local_ports {<portlist>} {mode [brief | normal | detailed]}
show lldp remote_ports {<portlist>} {mode [brief | normal | detailed]}
show lldp statistics
show lldp statistics
ports {<portlist>}