xStack
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
235
DGS-3627:5#show 802.1x auth_configuration ports 1
Command: show 802.1x auth_configuration ports 1
802.1X : Enabled
Authentication Mode : Port_based
Authentication Protocol : Radius_EAP
Port number : 1
Capability : None
AdminCrlDir : Both
OpenCrlDir : Both
Port Control : Auto
QuietPeriod : 60 sec
TxPeriod : 30 sec
SuppTimeout : 30 sec
ServerTimeout : 30 sec
MaxReq : 2 times
ReAuthPeriod : 3600 sec
ReAuthenticate : Disabled
CTRL+C
ESC
q
Quit
SPACE
n
Next Page
Enter
Next Entry
a
All
show 802.1x auth_state
Purpose
Used to display the current authentication state of the 802.1X server on
the Switch.
Syntax
show 802.1x auth_state {ports [<portlist> | all]}
Description The
show 802.1x auth_state
command is used to display the current
authentication state of the 802.1X Port-based or MAC-based Network
Access Control server application on the Switch.
Parameters
ports <portlist>
−
Specifies a port or range of ports to be viewed. The
beginning and end of the port list range are separated by a dash. Non-
contiguous portlist entries are separated by a comma. (ex: 1-3, 7-9)
all
– Specify to view all ports.
The following details are displayed:
Port number
−
Shows the physical port number on the Switch.
Auth PAE State: Initialize / Disconnected / Connecting / Authenticating /
Authenticated / Held / ForceAuth / ForceUnauth / Aborting
−
Shows the
current state of the Authenticator PAE.
Backend State: Request / Response / Fail / Idle / Initialize / Success /
Timeout
−
Shows the current state of the Backend Authenticator.
Port Status: Authorized / Unauthorized
−
Shows the result of the
authentication process. Authorized means that the user was
authenticated, and can access the network. Unauthorized means that the
user was not authenticated, and cannot access the network.
Restrictions None.
Example usage:
To display the 802.1X authentication state for Port-based 802.1X:
