xStack
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
369
show ospf virtual_neighbor
Purpose
Used to display the current OSPF virtual neighbor router table.
Syntax
show ospf virtual_neighbor {<area_id> <neighbor id>}
Description
This command will display the current OSPF virtual neighbor router table.
Parameters
<area_id>
−
A 32-bit number in the form of an IP address (xxx.xxx.xxx.xxx) that
uniquely identifies the OSPF area in the OSPF domain.
<neighbor_id>
−
The OSPF router ID for the neighbor. This is a 32-bit number in
the form of an IP address (xxx.xxx.xxx.xxx) that uniquely identifies the remote
area’s Area Border Router.
Restrictions None.
Usage example
To display the current OSPF virtual neighbor table:
DGS-3627:5#show ospf virtual_neighbor
Command: show ospf virtual_neighbor
Transit Router ID of IP Address of Virtual Neighbor
Area ID Virtual Neighbor Virtual Neighbor State
--------------- ---------------- ---------------- ----------------
10.1.1.1 10.2.3.4 10.48.74.111 Exchange
Total Entries : 1
DGS-3627:5#
config ospf ipif
Purpose
Used to configure the OSPF interface settings.
Syntax
config ospf [ipif <ipif_name 12> | all] {area <area_id> | priority <value> |
hello_interval <sec 1-65535> | dead_interval <sec 1-65535> | authentication
[none | simple <password 8> | md5 <key_id 1-255>] | metric <value 1-65535>
| state [enable | disable] | passive [enable | disable]}
Description
This command is used to configure the OSPF interface settings.
Parameters
<ipif_name 12>
−
The name of the IP interface.
all
- All IP interfaces.
area <area_id>
−
A 32-bit number in the form of an IP address (xxx.xxx.xxx.xxx)
that uniquely identifies the OSPF area in the OSPF domain.
priority <value>
−
The priority used in the election of the Designated Router (DR).
A number between
0
and
255
.
hello_interval <sec 1-65535>
−
Allows the specification of the interval between
the transmission of OSPF Hello packets, in seconds. Between
1
and
65535
seconds can be specified. The Hello Interval, Dead Interval, Authorization Type,
and Authorization Key should be the same for all routers on the same network.
dead_interval <sec 1-65535>
−
Allows the specification of the length of time
between the receipt of Hello packets from a neighbor router before the selected
area declares that router down. An interval between
1
and
65535
seconds can be
specified. The Dead Interval must be evenly divisible by the Hello Interval.
metric <value 1-65535 >
−
The interface metric (
1
to
65535
). Entering a 0 will
allow automatic calculation of the metric.
authentication
– Enter the type of authentication preferred. The user may choose
between:
•
none
– Choosing this parameter will require no authentication.
