xStack Gigabit Layer 3 Switch Command Line Interface Manual
config ospf all
interval between the transmission of OSPF Hello packets, in
seconds. Between 1 and 65535 seconds can be specified. The
Hello Interval, Dead Interval, Authorization Type, and Authorization
Key should be the same for all routers on the same network.
dead_interval <sec 1-65535>
−
Allows the specification of the
length of time between the receipt of Hello packets from a neighbor
router before the selected area declares that router down. An
interval between 1 and 65535 seconds can be specified. The Dead
Interval must be evenly divisible by the Hello Interval.
•
none
– Choosing this parameter will require no
authentication.
metric <value 1-65535 >
−
The interface metric (1 to 65535).
Entering a 0 will allow automatic calculation of the metric.
authentication
– Enter the type of authentication preferred. The
user may choose between:
metric <value 1-65535>
−
This field allows the entry of a number
between 1 and 65,535 that is representative of the OSPF cost of
reaching the selected OSPF interface. The default metric is 1.
state [enable | disable]
– Used to enable or disable this function.
Restrictions Only
administrator-level users can issue this command.
•
simple <password 8>
−
Choosing this parameter will set a
simple authentication which includes a case-sensitive
password of no more than 8 characters.
•
md5 <key_id 1-255>
−
Choosing this parameter will set
authentication based on md5 encryption. A previously
configured MD5 key ID (1 to 255) is required.
Usage Example
To configure all of the OSPF interfaces on the Switch with a single group of parameters:
DGS-3324SRi:4#config ospf all state enable
Command: config ospf all state enable
Success.
DGS-3324SRi:4#
show ospf ipif
Purpose
Used to display the current OSPF interface settings for the
specified interface name.
Syntax
show ospf ipif {<ipif_name 12>}
Description
This command will display the current OSPF interface settings for
the specified interface name.
Parameters
<ipif_name 12>
−
The IP interface name for which to display the
current OSPF interface settings.
324