xStack Gigabit Layer 3 Switch Command Line Interface Manual
create access_profile (ipv6)
Parameters
ipv6
– Denotes that IPv6 packets will be examined by the Switch for
forwarding or filtering based on the rules configured in the
config
access_profile
command for IPv6. IPv6 packets may be identified
by the following:
profile_id <value 1-8>
- Specifies an index number between 1 and 8
that will identify the access profile being created with this command.
Restrictions Only
administrator-level users can issue this command.
•
class
– Entering this parameter will instruct the Switch to
examine the
class
field of the IPv6 header. This class field is a
part of the packet header that is similar to the Type of Service
(ToS) or Precedence bits field in IPv4.
•
flowlabel
– Entering this parameter will instruct the Switch to
examine the
flow label
field of the IPv6 header. This flow label
field is used by a source to label sequences of packets such as
non-default quality of service or real time service packets.
•
source_ipv6_mask <ipv6mask>
- Specifies an IP address
mask for the source IPv6 address.
•
destination_ipv6_mask <ipv6mask>
- Specifies an IP address
mask for the destination IPv6 address.
Example usage:
To create an access profile based on IPv6 classification:
DGS-3324SRi:4#create access_profile ipv6 class flowlabel profile_id 4
DGS-3324SRi:4#
Command: create access_profile ipv6 class flowlabel profile_id 4
Success.
config access_profile profile_id (ipv6)
Purpose
Used to configure the IPv6 access profile on the Switch and to
define specific values for the rules that will be used to by the Switch
to determine if a given packet should be forwarded or filtered. Masks
entered using the
create access_profile
command will be
combined, using a logical AND operational method, with the values
the Switch finds in the specified frame header fields.
Syntax
config access_profile profile_id <value 1-8> add access_id
<value 1-100> ipv6 {class <value 0-255> | flowlabel <hex 0x0-
0xfffff> | source_ipv6 <ipv6addr> | destionation_ipv6
<ipv6addr>} port <port> [permit {priority <value 0-7>
{replace_priority}} | deny] | delete <value 1-100>]
Description
This command is used to define the rules used by the Switch to
either filter or forward packets based on the IPv6 part of each packet
header.
Parameters
profile_id <value 1-8>
- Enter an integer between 1 and 8 that is
used to identify the access profile that will be configured with this
231
