xStack
®
DES-3810 Series Layer 3 Managed Ethernet Switch Web UI Reference Guide
64
Trap
Enable or disable the MPLS trap state here.
Click the
Apply
button to accept the changes made.
MPLS Static LSP Settings
This window is used to configure the MPLS static LSP settings.
To view this window, click
VPN > MPLS > MPLS Static LSP Settings
as shown below:
Figure 4-16 MPLS Static LSP Settings window
The fields that can be configured are described below:
Parameter
Description
LSP Type
Select to establish a static
Egress
LSP or a static
Ingress
LSP here.
LSP Name
Enter the LSP name used here. This name can be up to 16 characters long.
IP Prefix
Enter the IP prefix FEC address of the LSP here. The specified FEC will map to the LSP.
In Label
Enter the incoming label value used here.
In Interface
Enter the incoming interface name used here. This name can be up to 12 characters long.
Nexthop
Enter the next hop IP address used here.
Out Label
Enter the outbound label value used here.
EXP
Enter the EXP value used here. By default the EXP is set according to the QoS of the
incoming packet. If the EXP is specified, the EXP of the outbound label will be set
according to specified value. This value must be between 0 and 7.
Click the
Add
button to add a new entry.
Click the
Find
button to locate a specific entry based on the information entered.
Click the
View All
button to display all the configure entries.
Click the
Delete All
button to remove entries in the list.
Click the
View Detail
link to navigate to a new window containing more detailed information about the entry.
After click the
View Detail
link, the following page will be displayed.
Figure 4-17 MPLS LSP Detail window
Click the
<<Back
button to return to the previous page.
Summary of Contents for xStack DES-3810
Page 1: ......
