xStack
®
DES-3810 Series Layer 3 Managed Ethernet Switch Web UI Reference Guide
243
Action
Select
Permit
to specify that the packets that match the access profile are forwarded by
the Switch, according to any additional rule added (see below).
Select
Deny
to specify that the packets that match the access profile are not forwarded by
the Switch and will be filtered.
Select
Mirror
to specify that packets that match the access profile are mirrored to a port
defined in the port mirror section. Port Mirroring must be enabled and a target port must
be set.
Priority
Tick the corresponding check box if you want to re-write the 802.1p default priority of a
packet to the value entered in the Priority field, which meets the criteria specified
previously in this command, before forwarding it on to the specified CoS queue.
Otherwise, a packet will have its incoming 802.1p user priority re-written to its original
value before being forwarded by the Switch.
Replace Priority
Select and enter the replace priority value used here.
Replace DSCP
Select this option to instruct the Switch to replace the DSCP value (in a packet that meets
the selected criteria) with the value entered in the adjacent field. When an ACL rule is
added to change both the priority and DSCP of an IPv4 packet, only one of them can be
modified due to a chip limitation. Currently the priority is changed when both the priority
and DSCP are set to be modified. This value must be between 0 and 63.
Replace ToS
Precedence
Specifies that the IP precedence of the outgoing packet is changed with the new value. If
used without an action priority, the packet is sent to the default TC. This value must be
between 0 and 7.
Time Range Name
Tick the check box and enter the name of the Time Range settings that has been
previously configured in the
Time Range
Settings
window. This will set specific times
when this access rule will be implemented on the Switch.
Counter
Here the user can select the counter. By checking the counter, the administrator can see
how many times that the rule was hit.
Ports
Enter the list of ports, used for this rule, here.
Click the
Apply
button to accept the changes made.
Click the
<<Back
button to discard the changes made and return to the previous page.
After clicking the
Show Details
button in the
Access Rule List
, the following page will appear:
Figure 8-7 Access Rule Detail Information window (Ethernet ACL)
Click the
Show All Rules
button to navigate back to the Access Rule List.
Summary of Contents for xStack DES-3810
Page 1: ......