D-Link RG-S8606 B, Installation And Reference Manual

Page: 61 / 116

Laser Safety
Among the modules supported by RG-S8614/S8610/S8606/S8606 B, there are a great number of optical modules that
are Class I laser products. Therefore, pay attention to the following during your use of this product:

When a fiber transceiver works, ensure that the port has been connected with an optic fiber so as to keep out dust
and avoid burning your eyes.

Cover the unused optical ports with dust caps.

Do not stare into any optical port.

Do not get close to or stare into any optical port under any circumstances, as this may cause permanent damage to
your eyes.
Installation Site Requirements
RG-S8614/S8610/S8606/S8606 B must be used in the room. To ensure normal operation and a prolonged use life of the
equipment, the installation site must meet the following requirements.
Rack Mounting Requirements
To mount the RG-S8614/S8610/S8606/S8606 B in a frame, verify that the frame meets the following conditions:

Install the switch in an open cabinet as much as possible. If you install the switch inside an enclosed cabinet, be sure
that the cabinet has a good ventilation and heat dissipation system.

Be sure that the cabinet is firm enough to bear the weight of the RG-S8614/S8610/S8606/S8606 B and its
installation accessories.

Be sure that the dimensions of the cabinet is appropriate for installation of the RG-S8614/S8610/S8606/S8606 B that
can reserve a certain space for the front, rear, left and right panels for heat dissipation.

The frame should be properly grounded.
Ventilation and Heat Dissipation Requirements

Sufficient space (10 cm at least) must be reserved at the air intakes and exhaust vents for ventilation.

After connecting various cables, you should bundle the cables or place them in the cable management bracket to
avoid blocking air inlets.