D-Link DXS-3250 - xStack Switch - Stackable, Cli Manual

Page: 83 / 466

D-Link CLI Reference Guide
Page 82
sntp server
The sntp server Global Configuration mode command configures the device to use the Simple Network Time
Protocol (SNTP) to request and accept SNTP traffic from a specified server. To remove a server from the list of
SNTP servers, use the
no form of this command.
Syntax
sntp server { ip-address | hostname }[ poll ] [ key keyid ]
no sntp server { ip-address | hostname }
Parameters
•
ip-address — IP address of the server.
•
hostname — Hostname of the server. (Range: 1-158 characters)
•
poll — Enable polling.
•
keyid — Authentication key to use when sending packets to this peer.
(Range:1-4294967295)
Default Configuration
No servers are defined.
Command Mode
Global Configuration mode
User Guidelines
Up to 8 SNTP servers can be defined.
Use the sntp unicast client enable Global Configuration mode command to enable predefined unicast clients
globally.
To enable polling you should also use the sntp unicast client poll Global Configuration mode command for
global enabling.
Polling time is determined by the sntp client poll timer Global Configuration mode command.
Examples
The following example configures the device to accept SNTP traffic from the server on 192.1.1.1.
Console(config)# sntp server 192.1.1.1