D-Link DXS-3250 - xStack Switch - Stackable, Cli Manual

Page: 49 / 466

D-Link CLI Reference Guide
Page 48
bridge multicast address
The bridge multicast address Interface Configuration (VLAN) mode command registers a MAC-layer multicast
address in the bridge table and statically adds ports to the group. To unregister the MAC address, use the no form
of this command.
Syntax
bridge multicast address { mac-multicast-address | ip-multicast-address }
bridge multicast address { mac-multicast-address | ip-multicast-address } [ add | remove ] { ethernet interface-list
| port-channel port-channel-number-list }
no bridge multicast address { mac-multicast-address | ip-multicast-address }
Parameters
•
add — Adds ports to the group. If no option is specified, this is the default option.
•
remove — Removes ports from the group.
•
mac-multicast-address — A valid MAC multicast address.
•
ip- multicast-address — A vaid IP multicast address.
•
interface-list — Separate nonconsecutive Ethernet ports with a comma and no spaces; a hyphen is used to
designate a range of ports.
•
port-channel-number-list — Separate nonconsecutive port-channels with a comma and no spaces; a hyphen
is used to designate a range of ports.
Default Configuration
No multicast addresses are defined.
Command Mode
Interface configuration (VLAN) mode
User Guidelines
If the command is executed without add or remove , the command only registers the group in the bridge database.
Static multicast addresses can only be defined on static VLANs.
Examples
The following example registers the MAC address:
The following example registers the MAC address and adds ports statically.
Console(config)# interface vlan 8
Console(config-if)# bridge multicast address 01:00:5e:02:02:03
Console(config)# interface vlan 8
Console(config-if)# bridge multicast address 01:00:5e:02:02:03 add ethernet 1/1-9, 2/1