D-Link DGS-3212SR, Command Line Interface Reference Manual

Page: 127 / 269

DGS-3212SR Layer 3 Gigabit Switch
config mirror port
highest switch number, and the highest port number of the
range (also separated by a colon) are specified. The
beginning and end of the port list range are separated by a
dash. For example, 1:3 specifies switch number 1, port 3. 2:4
specifies switch number 2, port 4. 1:3-2:4 specifies all of the
ports between switch 1, port 3 and switch 2, port 4
−
in
numerical order.
rx
−
Allows the mirroring of only packets received by (flowing into)
the port or ports in the port list.
tx
−
Allows the mirroring of only packets sent to (flowing out of)
the port or ports in the port list.
both
−
Mirrors all the packets received or sent by the port or ports
in the port list.
Restrictions The Target port cannot be listed as a source port. Only
administrator-level users can issue this command.
Example usage:
To add the mirroring ports:
DGS-3212SR:4# config mirror port 1:5 add source ports 1:1-1:5 both
Command: config mirror port 1:5 add source ports 1:1-1:5 both
Success.
DGS-3212SR:4#
config mirror delete
Purpose Used to delete a port mirroring configuration.
Syntax
config mirror port <port> delete source port <portlist> [rx | tx
| both]
Description This command is used to delete a previously entered port
mirroring configuration.
Parameters
port <port>
−
This specifies the Target port (the port where
mirrored packets will be sent). The port list is specified by listing
the lowest switch number and the beginning port number on that
switch, separated by a colon. Then the highest switch number,
and the highest port number of the range (also separated by a
colon) are specified. The beginning and end of the port list range
are separated by a dash. For example, 1:3 specifies switch
number 1, port 3. 2:4 specifies switch number 2, port 4. 1:3-2:4
specifies all of the ports between switch 1, port 3 and switch 2,
port 4
−
in numerical order.
delete source port – Adding this parameter will delete source ports
115