D-Link DGS-3212SR Layer 2 Gigabit Ethernet Switch
Version
−
displays the version number of the stacking firmware.
RPS Status
−
displays the status of an optional Redundant Power Supply.
Model Name
−
displays the model name of the corresponding switch in a stack.
The switch’s current order in the switch stack is also displayed on the front panel, under the
STACK NO.
heading.
Alternatively, the stacking order can be manually assigned using the console’s Command Line Interface (CLI).
You can use the
show stacking
command to display the current switch stack information. The syntax of the
show stacking
command is as follows:
show stacking {mode/version}
Using the optional parameter
mode
displays only the stacking mode of the switches in the switch stack.
Using the optional parameter
version
displays only the stacking firmware version of the switches in the switch
stack.
Entering the
show stacking
command with no parameters returns all of the relevant stacking information for all
of the switches in the stack:
Figure 4-2. Console CLI show stack command
The same switch stack information is displayed in the console as is displayed in the Web-based management
agent.
The
config stack
command allows you to configure the switch stack manually.
The syntax of the
config stacking
command is as follows:
config stacking mode [enable|disable]
One of the parameters
enable|disable
must be entered along with the
config stacking mode
command. These
parameters have the following effects:
enable|disable
Enables or disables the switch’s stacking mode.
The following example configures the DGS-3212SR for stacking.
With the management station’s console connected to the serial port of the switch with the lowest MAC address,
enter the following command at the prompt:
config stacking mode enable
You can then use the
show stacking
command to verify the stacking configuration, as shown below:
36