D-Link DGS-3212SR Layer 2 Gigabit Ethernet Switch
Access Right
read_only
−
Specifies that SNMP community members using the
community string created with this command can only read the contents
of the MIBs on the switch.
read_write
−
Specifies that SNMP community members using the
community string created with this command can read from and write to
the contents of the MIBs on the switch.
SNMP Host Table
Use the
SNMP Host Table
to set up SNMP trap recipients.
Open the
Management
folder, and then the
SNMPV3
folder. Next, click on the
SNMP Host Table
link. This
will open the
SNMP Host Table
page, as shown below.
To delete an existing SNMP Host Table entry, click the corresponding
X
icon under the
Delete
heading.
To display the current settings for an existing SNMP Group Table entry, click the blue link for the entry under
the
Host IP Address
heading.
Figure 18-10. SNMP Host Table
To add a new entry to the switch’s SNMP Group Table, click the Add button in the upper left-hand corner of the
SNMP Host Table
page. This will open the
SNMP Host Table Configuration
page, as shown below.
Figure 18-11. SNMP Host Table Configuration
The following parameters can be set:
Parameter
Description
IP Address
Type the IP address of the remote management station that will serve as
the SNMP host for the switch.
SNMP Version
V1
– To specifies that SNMP version 1 will be used.
V2
– To specify that SNMP version 2 will be used.
V3
– To specify that the SNMP version 3 will be used.
97