Curtiss-Wright | PG Drives Technology
SK77981-14
78 | R-net Technical Manual | Chapter 3 – Programming
At 0% the parameter has no effect. The recommended value is 80%, however, if the wheelchair drive is considered to be jerky,
then reduce this value.
6.21
TREMOR DAMPING - (TRMOR)
This parameter can be used to reduce the effects of a user’s hand tremor.
The programmable range is 0% to 100%. The higher the value, the greater the damping that is applied
WARNING:
If using high values of Tremor Damping, pay particular attention to the stopping distance of the wheelchair, as it will be
increased.
6.22
FAST BRAKE RATE
This parameter sets the deceleration rate that is used while fast braking. Fast braking is when the joystick is pulled to the
reverse position to make a faster stop.
The programmable range is 0 to 200.
If the value is set lower than the Forward Deceleration value, then the latter value will be used.
7
CONTROLS
CONTROLS – GLOBAL
7.1
MOMENTARY SCREEN S ENABLED - (MOMENTA RY SCREENS)
This sets whether the large, momentary screens appear in between Profile and Speed setting changes.
The programmable options are Yes and No.
7.2
CHANGE PROFILE WHILE DRIVING - (CHGE PRF IN DRV)
This sets whether Profile changes are permitted while the wheelchair is driving.
The programmable options are Yes and No.
7.3
CHANGE SPEED WHI LE DRIVING - (SPD ADJ IN DRV)
This sets whether the Speed Down and Speed Up buttons are active while the wheelchair is driving.
The programmable options are Yes and No.
